Tuesday, 1 May 2012

cagiva mito 125 compression testing

compression testing is important on a 2 stroke and give an idication of piston / rings wear and general engine wear and tear .
compression tester cagiva mito




Buy compression testers here on Ebay UK or here on Amazon UK 

heres a video of a compression test and below some typical results and there general meanings.




To do a compression test properly -

Warm engine to operating temperature

Remove spark plug

Screw in compression tester

Open throttle wide open

Engine kill switch off

Hold starter button for a few seconds until maximum pressure is achieved



As a guideline:

80 psi - should be struggling to start no long left till failure

100 psi - very low change rings /  barrel
120 psi - rings wearing

150 psi - rings in as new condition for stock machines

180 psi - rings in as good condition for tuned machines




see more cagiva mito 125 posts here 



thanks for reading the Cagiva Mito 125 blog , if you would like to support us you can by  buying your Cagiva Mito 125 used parts   here on ebay uk   or buying  your new Cagiva Mito 125  here on Ebay UK  or for Cagiva Mito 125 accessories at Amazon uk here , or simply by donating  here .

BUY our ultimate Cagiva Mito 125 workshop manual bundle HERE 

You can also visit our sponsors website 125 sportsbikes and spares here .

No comments:

Post a Comment

Note: only a member of this blog may post a comment.